VenSearch

FAA pauses copper-to-fiber router rollout after nationwide aviation ground stop

VenSearch

VenSearch

· 1 min read

A router installed during a copper-to-fiber cabling upgrade at a remote FAA communications facility caused a cascade of network instability on November 13, 2026, prompting the agency to issue a nationwide aviation ground stop that lasted more than four hours. The ground stop disrupted radar feeds and communications at 17 of the 22 regional air traffic control centers.
Contractor L3Harris was replacing legacy copper telecommunications wiring with fiber-optic lines at a site in El Dorado, Arkansas, when either a faulty router or a contractor error caused data to flood the FAA's wider network at approximately 1,000 connection attempts every four to five seconds. A router installed three weeks earlier in Amarillo, Texas, was also identified as a factor. The FAA has since paused all new Juniper router installations and disabled specific functionality on 60 existing units while the root cause remains under investigation. L3Harris noted it has completed more than 70% of the planned copper-to-fiber conversion across the FAA's airspace communications network, which covers 3,648 router replacements in total.
Facilities and IT managers overseeing active copper-to-fiber migrations in their own buildings may want to review their change-management and network-isolation procedures for infrastructure cutover work. The FAA incident illustrates how a hardware deployment at a single remote site can propagate instability across a much larger interconnected system if staging and rollback controls are not in place.

Sources

  1. 1.Cabling Installation & Maintenance ↗
  2. 2.The Washington Times ↗
  3. 3.ABC News ↗

Does this affect your business?

Our advisors can help you figure out the right move, at no cost.

Talk to an advisor